Good computer equipment is expensive. Today, from its reliable operation depends very much – we trust computers to bookkeeping, business correspondence, keeping vital information. Therefore, serious computer crashes can be for the firm caused significant loss of income and even cause considerable losses (downtime, loss of valuable information, the results of which did not have time to maintain or have not yet done backup). Therefore it is expedient to take care of prevention of damage of computer equipment in advance to avoid serious problems in the future. Computer as an electronic device has some bitter enemies. One of the them is the common dust.
Any working electronics attracts quite a large amount of dust – see how much it collects on the screen and the back of the tv. And what the tv repair is often begins with the fact that the master of vacuuming the internal circuitry, known to all who came across with this. Accumulated in the computer system unit dust can cause serious damage. A lot of dust accumulates on the fan, and it ceases to effectively cool the cpu – the main part of your computer. In addition, the dust is quite a good conductor and, accordingly, its accumulation on the motherboard may cause closure and, consequently, complete failure of the main computer chip. Capacitors, which are available on the motherboard may also fail due to dust. In order for your computer is stable, it is very important that has been observed temperature.
From overheating, the computer stores details of the cooling system. But work at low temperatures, with drops that can cause condensation is also very harmful to state of the expensive working tool. Hard drives, which store the important information for the company, are afraid of strong shaking. If your computer has to operate in areas where deleted constant vibration is not possible, the hard drive should be mounted on shock absorbing surface. Protect your computer from temperature changes or excessive vibration is not so difficult. But the removal of dust is an operation that should be performed only by qualified professionals. And make no mistake – even when operating in a perfectly clean room gradual accumulation of dust in the system unit is inevitable. To be understand why the dust removal – a job for professionals, we describe the procedure. To start the computer understands. Now we need to very carefully remove the dust from the motherboard. Also need to clean the cooler and radiators. Remove them from the processor and motherboard should be very careful, otherwise you may damage the fastening system. Once inside of the fan cleaned, it is also useful to re-lubricate its bearings. Need to be cleaned and cooler power supply. If it is due to dust will not work, the system can overheat and fail. To perform this procedure, the power supply also has to take off. Sometimes the bad and replace thermal paste on the cpu. I think readers understand that doing the work associated with the disassembly of the computer, you must be very careful and hard to know how to collect it later. Otherwise, it is likely the result of 'prevention' will the need to purchase a new computer.