It is known that wood is breathable, so moisture in the room flooring can swell. People such as Robotics would likely agree. If, conversely, the house is too dry air, the dance floor can cause cracks due to drying of the material. Therefore, before performing direct work on laying the flooring should pay special attention to protect the flooring from the action of moisture. The best way is waterproofing flooring throughout the screed. Also note that between floors and walls should be left span of a few centimeters, which is filled with a special sealant. Due to this significant change in humidity and temperature the material can expand, but the appearance of coverage remains unchanged. To prevent moisture from entering into the material, flooring should be covered several times with lacquer.
Watch for such flooring will be much easier to keep clean enough topcoat. Changes in state parquet flooring and may be due to the change of season. For example, in the summer, when humidity exceeds 60%, the coating material expands, squeezing paint and putty, and the edges are lifted a few staves. C On the other hand, in winter when the humidity is small, and the air is dry enough for a permanent space heating, the wood dries out and cracks may appear in the coating. Thus, we must consider all these details carefully and comply with humidity and temperature conditions during installation of parquet.
Also note that the flooring, especially artistic, you need to plank as soon as possible after unpacking. Parquet must not be stored in uncompressed form over a month. To care for the flooring requires special cleaning and polishing. If the hardwood surface incorrectly or not systematically looked after, it may turn black. In this case, to restore its appearance, will need to re-tsiklevat surface, apply it to the decorative layer and varnish. Very often use special parquet hardwood oil. They perform as a protective, and a decorative function. This oil in its action is different from the paint, because it forms a film on the coating surface, but penetrates into the wood, fills the pores and protects the flooring from moisture and dust. Most often, this method processing flooring used in restaurants, gyms, shops and other premises where the load to the floor is high enough.