Tinting Automotive Glass

Today, many car owners tint windows of their cars. This helps protect you from ultraviolet radiation, to avoid the glare of bright flashes of light (from sun or headlights of cars), and harboring salon and its occupants from view. Toning can also be held in conjunction with the book data auto glass film. However, to successfully pass the inspection, you must comply established norms for toning panes car. According to a special special guest, 5727-88 as amended on January 1, 2002, the rate of light transmission to the windshield is 75%, while the front side windows – 70%. By the same author: Pete Cashmore. Allowed toning band width of 14 cm at the top of the windshield. Luc car can be toned up to 100%. Swarmed by offers, Code.org is currently assessing future choices. Mirror Tinted car windows, as well as toning optics, is not allowed.

Tinting the rear windshield and side windows may any color of arbitrary intensity, but only if the two outer rear-view mirrors. Checking for compliance with toning guests spend in the formulation of a car registered in inspection station, as well as on a stationary post dps (if there is no pass on passing inspection). To inspect the inspector should only technical supervision and control. Tester, light transmission Glass – taumeter – must be certified, tested and sealed. Most frequently used instruments “Lux” and “Blick”. However, there may be used and other taumeter committed to conducting this test. It must be remembered that the device is displayed on the scoreboard in the percentage is not the amount of absorbed light flux, and the number passing through toned glass. Thus, if the device shows a note “75%”, it means that the glass absorbs only 25% and therefore meets the requirements of gost. If the device is registered contrary to established norms of toning passing inspection, car owner issued a recommendation to eliminate shading. If violations were found during testing on a stationary post of dps, the car owner penalized for 500 rubles. In some cases, the inspector may dispense a warning.

Operating Engines

By the nature of activity I have to answer many technical questions. So as not to waste my time henceforth begin to publish an article on jamz engines, their design and operation. ymz powerful, reliable and easy to use, but remember that the life of any technology depends largely on the regular and thorough care for her. Proper operation of the power unit and long life are in direct Depending on the culture of exploitation. Before use carefully read the manual that came with each engine.

It is very important to observe the rules of operation by running a new engine, as this period there is burn-in of the rubbing surfaces. It is also necessary to use fuels, lubricants and fluids designed specifically for this engine. Before starting the engine after the oil change, Oil filter element, long-term (5 days or more) parking lot, replacement or repair of assembly units and parts, install the bracket stop to position and feed off within 10-15 seconds of cranking crankshaft starter motor. If oil pressure is – you can start the engine, in the absence of – start to repeat after 1-2 minutes. After starting the engine should run at idle speed not exceeding 1000 min-1 but not more than 5 min. After start warming up the engine to operating temperature 75-90 C to produce under load, you should not warm up the engine, allowing his long work at the minimum rotation frequency of idling. Once the engine will respond to changes in fuel and brake system will ensure the normal working pressure, gradually increase speed to medium and start working traffic at lower gears.